2.Unfold liner completely

3.Begin hanging at front corner of container

4.Move towards rear inserting rubber bands into hanging clips

5.Attach filling spout fastening both sides of each filling hatch

6.Move towards rear attaching all filling spouts of liner

7.Insert opposite front corner rubber band into corner hanging clip

8.Move towards rear inserting rubber bands into hanging clips

9.From front,peeling back paper from double sided tape,pulling backwards and outwards

10.Ensure base liner is fitted against edges of container and is free from creases

11.Attach any remaining rubber bands on liner end

12.Insert rubber bands at ends of discharge hold up cord into side clips

13.Check that discharge is slightly clear of floor

14.Attach rubber band to hanging clip on door